Modular Wiring Routing, Disconnecting And Connecting, Bucket Seat
Individual Wire, Removing
Risk of injury due to involuntary deployment.
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Secure the front seat to the Engine/Transmission Holder - Seat Repair Fixture:VAS 6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- If equipped, unclip the rear bracket for the wire routing on the seat pan using a flat-head screwdriver.
-- Separate the cable holder -2 and 5- and cable tie -3 and 4-.
-- Remove the single wire from the protective cover -1-.
-- Replacing a faulty wire. Refer to WIRING HARNESSES AND CONNECTORS, REPAIRING .
Individual Wire, Installing
Repairing pyrotechnic components (for example the airbag and seat belt tensioner) incorrectly increases the risk of unintentional deployments when the battery is connected.
- Follow the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS DURING ROAD TEST WITH TESTING EQUIPMENT .
- Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
- Follow all the instructions when installing the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
Install in the reverse order of removal while noting the following:
-- When bundling and placing individual wires, make sure the wires are not twisted.
During installation, all cable ties, cable holders and clips must be installed at the same location.
Make sure the connectors are pushed in all the way and that they engage audibly.