Pneumatic Lines, Disconnecting And Connecting
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Hose Cutting Pliers:VAS 6228
- Pneumatic Repair Set - Pliers :VAS 6618/1 (Quantity 2), not illustrated
Pneumatic Line, Cutting
-- Position the Hose Cutting Pliers:VAS 6228 at a right angle and cut the pneumatic line -1-.
Pneumatic Line, Connecting
-- Slide the pneumatic lines -1- and -3- onto the line connector -2- on both sides using the Pneumatic Repair Set - Pliers :VAS 6618/1 . Refer to the appropriate Electronic Parts Information.