Overview - Pneumatic System

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Pneumatic System

Courtesy of AUDI

Bracket
- Clip into the seat pan
Rubber Mounting
- Quantity: 3
- Engage in the bracket
Pneumatic System Pump Bracket
Lumbar Support Adjustment Pump
- Clip to the bracket
- Refer to Driver Lumbar Support Adjustment Pump -V152- / Front Passenger Lumbar Support Adjustment Pump -V153-, REMOVING AND INSTALLING
Clip
- Replace after removing
Right Air Cushion for Backrest Bolster Adjustment
- Only for Super Sport seat
- Refer to BACKREST BOLSTER ADJUSTER AIR CUSHION, REMOVING AND INSTALLING
Lumbar Support with Air Cushion
- Refer to LUMBAR SUPPORT AIR CUSHION, REMOVING AND INSTALLING
Rubber Mounting
- Quantity: 3
- Engage in the lumbar support and the valve block
Seat Bolster/Backrest Inflation Adjustment Valve Block
- Refer to Front Passenger Multi-Contour Seat Control Module - J872- /Driver Multi-Contour Seat Control Module - J873-, REMOVING AND INSTALLING
Left Air Cushion for Backrest Bolster Adjustment
- Only for Super Sport seat
- Refer to BACKREST BOLSTER ADJUSTER AIR CUSHION, REMOVING AND INSTALLING
Bolt
- 6.5 Nm
O-Ring
- Replace after removing