LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2023 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 71 (Passenger Protection, Airbags, Seat Belts (Coupe)) >> 69 Passenger Protection, Airbags, Seat Belts >> Driver Side Airbag >> Connector On Airbag, Removing And Installing >> Installing

Connector On Airbag, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.
WARNING:

Risk of injury due to involuntary deployment.

  • Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
  • Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
  • To prevent electrostatic charge, the technician must not leave the vehicle during the procedure.

-- Connect the connector -1- to the airbag igniter -arrow A-.

Fig 1: Release Connector Lock Using A Small Screwdriver & Disconnect Harness Connector
GWWA69-10923Courtesy of AUDI

-- Press in the connector lock -2- -arrow B-. While doing this, the connector is pushed into the airbag igniter all the way and locks into place.

Install in reverse order of removal. Note the following:

NOTE:

Make sure the connectors are pushed in all the way and that they engage audibly.

scientia non olet · About LEMON Manuals