Driver Front Airbag Crash Sensor -G283-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different variant/trim than selected.
WARNING:
Risk of injury due to involuntary deployment.
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
-- Disconnect the battery ground cable when the ignition is turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Driver Front Airbag Crash Sensor -G283-, g-tron: remove the engine compartment battery. Refer to BATTERY, REMOVING AND INSTALLING .
-- Front Passenger Airbag Crash Sensor -G284- : remove bolts -arrows-, then remove the air guide -2-.
-- Remove the screw -1- and then remove the front airbag crash sensor -2- from the lock carrier.
WARNING:
Risk of injury due to involuntary deployment.
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Disconnect the connector -3-.
-- To do this pull out the connector lock -2-, push down -arrow-, and disconnect the connector -1- on the crash sensor.