Telephone BASEPLATE, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Turn off the ignition and all electrical equipment. Set the ignition key outside of the vehicle.

The Telephone Baseplate -R126- / the Mobile Device Charger 1 -J1146- -1- is installed in the multimedia device storage compartment.

Courtesy of AUDI OF AMERICA, LLC

The rubber lip on the surface on which the Removal Tool for Coupling - Aerial:T40388 was inserted must be slightly pressed out.

-- Carefully press the rubber lip at the Telephone Holder - R126- / at the Mobile Device Charger 1 -J1146- to the side, using the Removal Tool for Coupling - Aerial:T40388 -A- and insert the Removal Tool for Coupling - Aerial:T40388 vertically from above as shown.

-- The catch -2- is released and engages in the groove on the Removal Tool for Coupling - Aerial:T40388 -A-.

-- Pull the Removal Tool for Coupling - Aerial:T40388 -A- back out vertically upward and remove the Telephone Baseplate -R126- / the Mobile Device Charger 1 -J1146- -1- from the storage compartment.

-- The Telephone Baseplate -R126- / the Mobile Device Charger 1 -J1146- is clipped on the opposing side. Swivel the Telephone Baseplate -R126- / the Mobile Device Charger 1 -J1146- -1- out of the storage compartment.

-- Release and disconnect the connectors at the Telephone Holder -R126- / at the Mobile Device Charger 1 -J1146-.