Calibration Requirements

• The camera lens must be clean.
• The vehicle must be standing on a firm and level surface.
• There must be sufficient open space around the vehicle.
• The parking brake must be set.
• The steering wheel must be in the 0 position and the wheels must be straight.
• All doors and the rear lid must be closed.
• No one should be in the vehicle.
• The vehicle must not be loaded (curb weight).
• Before each calibration: turn on the ignition.

Special tools and workshop equipment required 

• Calibration Unit:VAS 6350A 
  Fig 1: Calibration Device VAS 6350

  Courtesy of AUDI OF AMERICA, LLC

The Calibration Unit:VAS 6350A  consists of the following parts:

• Calibration Tool - Wheel Center Mountings:VAS 6350/1 
• Calibration Tool - Spacing Laser:VAS 6350/2 
• Calibration Tool - Linear Laser:VAS 6350/3