Requirement for the calibration of the vehicle
WARNING: This page is about a different variant/trim than selected.
- Camera lens must be cleaned, only clean the camera lenses with a wet towel.
- Check the camera images on the Front Information Display Control Head -J685-. Replace the camera if the images are unclear because the camera has been damaged. Check the fastener for the camera if the image is low.
- Make sure both exterior rearview mirrors are folded out.
- The parking brake must be set.
- The steering wheel must be in the 0 position and the wheels must be straight.
- All doors and the rear lid must be closed.
- No one should be in the vehicle.
- The vehicle must not be loaded (curb weight).
- The battery charger is connected, the battery charger must not be in the view of the camera.
- Ignition switched on.
- The system is active and is displayed on the Front Information Display Control Head -J685-.
- Do not move the vehicle during the calibration process.
Requirements for the calibration equipment/calibration environment
- flat calibration surface
- Do not use any objects in the environment of the calibration field, to prevent a false recognition of lines
- Even light (no headlamps or direct illumination), prevent strong light differences
Special tools and workshop equipment required
- Calibration System:VAS 721 001