CONNECTION DIAGRAM - EVAP SYSTEM, VEHICLES WITH Fuel Tank Pressure Sensor -G400-
WARNING: This page is about a different variant/trim than selected.
NOTE:
The connection diagram applies to TFSI vehicles.
The lines on the vehicle are not colored.
- Vent Line
- Vents out to the right rear under the wheel housing liner
- Fuel Tank Pressure Sensor -G400-
- Bleeder Line
- To the EVAP Canister Purge Regulator Valve 1 -N80-
- Bleeder Line
- From the fuel tank
- EVAP Canister
- EVAP Canister Purge Regulator Valve 1 -N80-