Valve Stem Seals, Removing And Installing, Cylinder Head Removed: Notes

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Puller - Valve Seal:3364

Fig 1: Identifying Puller - Valve 3364
Courtesy of AUDI OF AMERICA, LLC
Seal Installer - Valve Stem:3365 for the valve stem seal with a single sealing lip. Refer to Figure.

Fig 2: Identifying Seal Installer - Valve Stem 3365
Courtesy of AUDI OF AMERICA, LLC
Fitting Tool:T40376/1 for the valve stem seal with a double sealing lip. Refer to Figure.

Fig 3: Exhaust side: Fitting Tool
Courtesy of AUDI OF AMERICA, LLC
Valve Keeper Tool Kit:VAS 5161A with the Valve Cotter Tool Kit - Guide Plate:VAS 5161/19C

Fig 4: Valve Keeper Tool Kit VAS5161A
Courtesy of AUDI OF AMERICA, LLC
Engine and Gearbox Bracket:VAS 6095A

Fig 5: Engine And Transmission Holder
Courtesy of AUDI OF AMERICA, LLC
Cylinder Head Tensioning Device:VAS 6419

Fig 6: Cylinder Head Tensioning Device
Courtesy of AUDI OF AMERICA, LLC
Assembly Tool:T40452 , not illustrated