Needle Bearing In Drive Plate, Replacing

Only available with the manual transmission a needle bearing is installed in the drive plate.

Special tools and workshop equipment required 

• Press Piece - 31.5mm:VW418A 
  Fig 1: Identifying Press Piece

  Courtesy of AUDI OF AMERICA, LLC
• Press Piece - 28x100mm:VW421 
  Fig 2: Identifying Tube 28 mm Dia. 100 mm VW 421

  Courtesy of AUDI OF AMERICA, LLC
• Bearing Installer - Multiple Use:40-103 
  Fig 3: Bearing Installer - Multiple Use 40-103

  Courtesy of AUDI OF AMERICA, LLC
• Pneumatic hydraulic press, for example :VAS 6654  , not illustrated

Procedure

Fig 4: Identifying Drive Plate, Removal

Courtesy of AUDI OF AMERICA, LLC

• The transmission is removed. Refer to TRANSMISSION, REMOVING 7-Speed Dual Clutch Transmission , TRANSMISSION, REMOVING 8-Speed Automatic Transmission .

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Place the Bearing Installer - Multiple Use:40 - 103  under the drive plate to remove and install.

-- Press out the needle bearing using the Press Piece - 28x100mm:VW421  and workshop press.

• The thinner diameter of the Press Piece - 28x100mm:VW421  points towards the drive plate.

-- Carefully press the needle bearing in all the way using the Press Piece - 31.5mm:VW418A  and workshop press.

Fig 5: Identifying Drive Plate, Removal

Courtesy of AUDI OF AMERICA, LLC

• Installation position: the closed side of the needle bearing faces the engine.

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .