Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
- Transmission removed. Refer to TRANSMISSION, REMOVING 7-Speed Dual Clutch Transmission or TRANSMISSION, REMOVING 8-Speed Automatic Transmission .
-- Insert the Counterhold - Flywheel:10 - 201 to loosen the bolts.
CAUTION:
Risk of damaging the outer surface of the bearing flange at the drive plate if using unsuitable tools.
- Use an internal multi-point socket with a shaft that is at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts and remove the drive plate -1-.