Vibration Damper, Removing And Installing, Version 1, Vehicle With Starter Generator: Notes

WARNING: This page is about a different variant/trim than selected.

Vibration Damper, Version 1. Refer to Figure.

Special tools and workshop equipment required

Counterhold:T40378

Fig 1: Counterhold T40378
Courtesy of AUDI OF AMERICA, LLC
Vibration Damper Assembly Tool:T10531

Fig 2: Assembly Tool Set T10531
Courtesy of AUDI OF AMERICA, LLC
Vibration Damper Assembly:T10531/5-/6

Fig 3: Vibration Damper Assembly
Courtesy of AUDI OF AMERICA, LLC

The vibration damper bolt -A- connects the vibration damper -1-, the timing chain sprocket -2- and the crankshaft -3- with each other. Before removing the bolt, the chain sprocket must be secured to the crankshaft as described in the following.

Fig 4: Locating Vibration Damper Bolt
Courtesy of AUDI OF AMERICA, LLC