LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2023 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 60 (Crankshaft, Cylinder Block (4-Cylinder Direct Injection 2.0L 4V TFSI Engine (Ea 888EVO4)) (Coupe)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Ribbed Belt, Removing And Installing, Vehicle With Generator >> Installing

Ribbed Belt, Removing And Installing, Vehicle With Generator: Installing

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal while noting the following:

-- Install the ribbed belt. Refer to Figure.

-- Turn the tensioner slightly clockwise -arrow- and remove the Locking Pin:T10060A  .

-- Release the tension on the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Start the engine and check whether the ribbed belt runs correctly.

scientia non olet · About LEMON Manuals