LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2023 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 60 (Crankshaft, Cylinder Block (4-Cylinder Direct Injection 2.0L 4V TFSI Engine (Ea 888EVO4)) (Coupe)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt TENSIONER, Removing And Installing >> Ribbed Belt TENSIONING Damper, Removing And Installing, Vehicle With Starter Generator >> Notes

Ribbed Belt TENSIONING Damper, Removing And Installing, Vehicle With Starter Generator: Notes

WARNING: This page is about a different variant/trim than selected.

Removing

After each repair there are two possibilities for the removal of the ribbed belt tensioner:

1. If the ribbed belt is installed:

TIP:

If the ribbed belt tensioner should be replaced, a commercially available steel pin (4 mm diameter) can be used for securing the tensioner instead of the Locking Pin:T10060A  .

-- Remove the ribbed belt from the tensioner. Refer to RIBBED BELT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals