Overview - A-Pillar Trim Panel, A5 Coupe/SPORTBACK
WARNING: This page is about a different variant/trim than selected.
- A-Pillar Lower Trim Panel, Sportback
- Refer to A-PILLAR LOWER TRIM PANEL, REMOVING AND INSTALLING, A5 SPORTBACK
- Pushed forward in the carpet
- Stretch the inner door seal lip over.
- A-Pillar Lower Trim Panel, Coupe
- Refer to A-PILLAR LOWER TRIM PANEL, REMOVING AND INSTALLING, A5 COUPE/CABRIOLET
- Pushed forward in the carpet
- Stretch the inner door seal lip over.
- A-Pillar Gap Cover
- Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING
- Clip into the A-pillar trim panels
- Stretch the inner door seal lip over.
- Clamp with Hooks
- Replace after removing the A-pillar trim panel
- Insert in the trim panel
- Retaining Pin
- 3.5 Nm
- Pop Rivet Nut
- Riveted into the A-pillar
- Clip
- Insert in the trim panel
- Remove the clips that are still in the body mounting points using the Omega Clip Tool:T40280 .
- Replace damaged or deformed clips
- A-Pillar Upper Trim Panel
- Refer to A-PILLAR UPPER TRIM PANEL, REMOVING AND INSTALLING, A5 COUPE/SPORTBACK
- Press on until it engages audibly
- Stretch the inner door seal lip over.
- Bolt
- Only driver side
- 2.5 Nm
- Clip
- Quantity: 4
- Insert in the trim panel
- Remove the clips that are still in the body mounting points using the Omega Clip Tool:T40280 .
- Replace damaged or deformed clips