Overview - Luggage Compartment Side Trim Panel, A5 Cabriolet
WARNING: This page is about a different variant/trim than selected.
- Clip
- Quantity: 4
- Insert in the trim panel
- Remove any clips remaining in the mounting points using the Omega Clip Tool:T40280 and insert them into the trim panel for installation.
- Replace damaged or deformed clips
- Clip
- Quantity: 3
- Insert in the trim panel
- Remove any clips remaining in the mounting points using the Omega Clip Tool:T40280 and insert them into the trim panel for installation.
- Replace damaged or deformed clips
- Trailer Hitch Button Trim
- Equipped on some models
- Removing and installing. Refer to COMPONENT LOCATION OVERVIEW - CONTROLS IN LUGGAGE COMPARTMENT .
- Service Cover Locking Bolt
- Clip into the knob
- Detent Plate for Service Cover Housing
- Clip on the housing
- Trim for Convertible Top Compartment Enclosure Control Button
- Clip into the trim panel
- Expanding Clip
- Removing with Pliers:T40172C
- Luggage Compartment Side Trim Panel
- Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING, A5 CABRIOLET
- Press on until it engages audibly
- Stretch the lip of the rear lid seal over
- Service Cover Locking Mechanism Housing
- Clip into the lock disc
- Service Cover Locking Mechanism Knob
- Clip into the lock bolt
- Bolt
- Quantity: 2
- 9 Nm
- Tie Down
- Quantity: 2
- Refer to TIE DOWN, REMOVING AND INSTALLING
- Tie Down Bracket
- Lock Carrier Trim Panel
- Refer to LOCK CARRIER TRIM PANEL, REMOVING AND INSTALLING
- must engage in the pins
- Press on until it engages audibly
- Stretch the lip of the rear lid seal over