High-Mounted Brake Lamp Bulb, Removing And Installing, Coupe: Removing

WARNING: This page is about a different variant/trim than selected.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the headliner. Refer to HEADLINER, REMOVING AND INSTALLING .

-- Open the mounting tabs and disconnect the connector -1-.

-- Remove the nuts -arrows-.

-- Pry out the retaining pin -2- on the outside using the Wedge Set:T10383/1 from the clip nuts -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Pry up the lamp -4- for the high-mounted brake lamp using the Wedge Set:T10383/1 from the body at the same time the seals -3- are loosened from the bonding.