Overview - Wheel Bearing, AWD

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Wheel Bearing, AWD

Courtesy of AUDI

Wheel Bearing Housing
- Removing and installing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING .
Bolt
- 80 Nm + 90°
- Replace after removing
Drive Axle
Bracket
- For wires
Bolt
- 13 Nm
- Thread cutting
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
Wheel Bearing
- Wheel Bearing Unit, Removing and Installing. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .
- At the moment only available with item 7
- Wheel Bearing Unit, Servicing. Refer to WHEEL BEARING UNIT, SERVICING .
- Handling the wheel bearing. Refer to Figure.
Wheel Hub
- At the moment only available with item 6
Bolt
- Drive Axle Threaded Connection, Loosening and Tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .