Drivetrain Control Module -J775-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal while noting the following:

-- Equipped on some models: install the rear air duct. Refer to OVERVIEW - AIR ROUTING AND AIR DISTRIBUTION IN VEHICLE INTERIOR .

-- Install the Access/Start System Antenna 1 in Vehicle Interior -R138-. Refer to COMPONENT LOCATION OVERVIEW - KEYLESS ACCESS AUTHORIZATION SYSTEM .

-- Install the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .

After reinstalling the Drivetrain Control Module -J775- (removed before):

-- Perform the basic setting of the electronic damping function. Refer to ELECTRONIC DAMPING BASIC SETTING .

After installing a new Drivetrain Control Module -J775- activate the control module:

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic operating mode.

-- Select the Test plan tab.

-- Select the Select individual test button and select the following tree structure consecutively:

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.