Overview - Wheel Bearing
WARNING: This page is about a different variant/trim than selected.
- Wheel Bearing Housing
- Removing and installing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING .
- Bolt
- 100 Nm +90°
- Replace after removing
- Drive Axle
- Wheel Bearing
- Wheel Bearing Unit, Removing and Installing. Refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .
- Removing and installing. Refer to WHEEL BEARING UNIT, SERVICING .
- Handling. Refer to Fig 2
- Wheel Hub
- The lateral run-out on the outer diameter of the wheel hub when installed can be a maximum of 0.02 mm.
- Measure the lateral run-out with the Dial Indicator - 0-10mm:VAS 6079 and Dial Indicator Bracket:VAS 6079/1
- Removing and installing. Refer to WHEEL BEARING UNIT, SERVICING .
- Bolt
- Replace after removing
- Before installing, clean the threads in the CV joint with a thread tap.
- Drive Axle Threaded Connection, Loosening and Tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
Wheel Bearing, Handling
CAUTION:
There is a risk of contaminating and damaging the seal.
- The wheel bearing -1- must always face up in order to remove the wheel bearing unit.
- Always set the wheel bearing unit down on the wheel hub -2-.