SUBFRAME CROSSBRACE, Removing And Installing: Notes

Special tools and workshop equipment required 

• Engine and Gearbox Jack:VAS 6931 
  Fig 1: Engine and Gearbox Jack VAS6931 or VAG1383A

  Courtesy of AUDI OF AMERICA, LLC
• Rear Axle Support:T10552 
  Fig 2: Rear Axle Support without Mounting Pin Threaded Sleeve and Support

  Courtesy of AUDI OF AMERICA, LLC
• Puller - Ball Joint:T40043 
  Fig 3: Ball Joint Puller T40043

  Courtesy of AUDI OF AMERICA, LLC
• Locating Pins:T40334 

  Courtesy of AUDI OF AMERICA, LLC

• Strut:T40335 
  Fig 4: Identifying Support Brace T40335

  Courtesy of AUDI OF AMERICA, LLC
• Adapter:T40386 

  Courtesy of AUDI OF AMERICA, LLC

Prepare the Rear Axle Support:T10552 

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the bolts -arrows-.

-- Adjust the dimension -a-.

• Dimension -a- = 250 mm.

-- Tighten the bolts to 10 Nm.

-- Loosen the bolt -right arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the dimension -b-.

Courtesy of AUDI OF AMERICA, LLC

• Dimension -b- = 370 mm.

-- Tighten the bolt -arrow- to 10 Nm.

-- Loosen the left and right lower Support Bolts:T10552/1  -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Adjust the dimension -c-.

• Dimension -c- = 155 mm.

-- Turn the left and right threaded sleeves on the Support Bolts:T10552/1  -3- until the dimension -d- is reached.

Courtesy of AUDI OF AMERICA, LLC

• Dimension -d- = 185 mm.

-- Position the adapter :T40386/1  and nut :T40386/2  on the support :T10552/2  and tighten by hand with the bolt -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Place the Rear Axle Support:T10552  -1- on the Engine and Gearbox Jack:VAS 6931  -2- -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolt -right arrow-.

Courtesy of AUDI OF AMERICA, LLC

• M6: 5 Nm.
• M8: 10 Nm.

Strut:T40335  , Preparing

Courtesy of AUDI OF AMERICA, LLC

• Noise insulation removed. Refer to OVERVIEW - NOISE INSULATION .

-- Measure the diameter of the hole in the subframe.

a -  17.6 mm

b -  15.6 mm

-- If necessary, loosen the set screw -1-.

-- Insert the Pin:T40335/1  on the correct side in the Strut:T40335  .

-- Tighten the set screw again.