Threshold "A" In Mm, Cabriolet
WARNING: This page is about a different variant/trim than selected.
NOTE:
If the readout value is greater than the threshold "a" (table value): insufficient damping effect → replace shock absorber.
If the readout value is less than the threshold "a" (table value): sufficient damping effect → shock absorber does not need to be replaced.
| Chassis | Front Axle | Rear Axle | Note |
|---|---|---|---|
| 1BA | 48 | 49 | no load tank full |
| 1BD | 46 | 49 | |
| 1BE | 48 | 49 | |
| 1BL / 2MV | -- | -- |