Self-adhesive sunroof seals, removing and installing:

-- Open the glass panel far enough until it is lifted at the front and rear.

-- Remove the seal, if necessary warm up additionally using the Hot Air Blower:V.A.G 1416  .

Install in the reverse order of removal while noting the following:

• The vehicle and the seal must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.
• Do not stretch the seal when installing it.

-- Remove the adhesive residue from the body.

-- Clean the adhesive surface with Cleaning Solution and let it dry.

-- Remove the protective film from adhesive tape.

-- Position the seal and press on along the entire length.

-- Perform an adaptation. Refer to Sunroof Motor -V1-, PROGRAMMING .

• Resting time approximately 30 minutes at room temperature