Sunroof Control Module -J245-, PROGRAMMING
WARNING: This page is about a different variant/trim than selected.
If the Power Sunroof Control Module -J245- was replaced, it must be activated after installing.
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Body
- Body Assembly
- 01 - OBD-capable systems
- CA - Power Sunroof Control Module J245
- CA - Power Sunroof Control Module J245 Functions
- CA - Control module, replacing
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.