LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2023 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (Hood, Lids (Coupe)) >> 55 Hood, Lids >> Rear Lid >> Adjusting Buffer, Removing And Installing >> Body Adjusting Buffer >> Installing

Body Adjusting Buffer: Installing

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal while noting the following:

TIP:

To secure the adjusting buffer, the Pop Rivet Screw:WHT 005 180  must be inserted using the Pop Rivet Pliers:V.A.G 1765C  and Pop Rivet Pliers - Supplement Pieces V.A.G 1765C/2. Refer to => 53 for detailed information. The >>infomedia search<< can be used here to search for the Pop Rivet Screw:WHT 005 180  in the respective chapter.

-- Adjust the adjusting buffer. Refer to HEIGHT, ADJUSTING USING ADJUSTING BUFFER .

scientia non olet · About LEMON Manuals