Left Parking Brake Motor -V282- /Right Parking Brake Motor -V283-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal while noting the following:

Replace the seal after removal.
The ring groove for the gasket and the parking brake motor contact surface must not be damaged.

-- Clean the parking brake motor ring groove and contact surface.

-- Install the new seal.

TIP:

Make sure that the gasket is not removed while assembling the parking brake motor.

-- Bring the parking brake motor -1- into the installation position while turning the parking brake motor back and forth slightly.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -arrows-.

The parking brake motor must be flush with the brake caliper. Under no circumstances may it be pulled against the brake caliper with bolts.

CAUTION:

Risk of damaging the threads due to improper handling.

- Never use an impact wrench to loosen or tighten.

- Position the bolts by hand and screw in the first threads.

-- After installation, select the "Electromechanical Parking Brake Control Module - J540" program. Refer to DIAGNOSTIC ENTRIES .

-- Follow the instructions in the Vehicle Diagnostic Tester display.

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.