Coolant Shut-Off Valve -N82-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following.
TIP
- Since only a small amount of coolant flowed out of the coolant circuit when removing the Coolant Shut-Off Valve -N82- as described above, the coolant flows into Coolant Shut-Off Valve -N82- after installing and removing the hose clamps (additionally opening the coolant expansion tank cap).
- The shut-off valve -A- is secured to the noise insulation via the rubber bushing -L- (with bearing bushings and washers) the nuts -G- and the bolts -F- on the bracket -K-.
-- Check the rubber bushing -L- is seated correctly in the bracket -K-.
-- Drain and fill the coolant circuit. Refer to BLEED COOLING SYSTEM - 2.0 or COOLANT, DRAINING AND FILLING - 2.9, 3.0 .
Tightening Specification
| Component | Tightening Specification |
|---|---|
| Coolant Shut-Off Valve -N82- on the bracket | 8 Nm |
| Bracket for the Coolant Shut-Off Valve -N82- on the plenum chamber | 8 Nm |