Left Side Vent Motor -V299-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different variant/trim than selected.
-- On vehicles with high-voltage system, switch on the "parking air conditioner" function (deactivate). Refer to the Owner's Manual.
-- Move the left front seat all the way to the rear.
-- Switch off the ignition.
-- Remove the mounting bracket for the pedal assembly. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING .
-- Label the connector -C- and the actuator -B- (to avoid a mix up in case several connectors are disconnected at the same time).
-- Remove the bolts -A-.
-- Remove the actuator -B- from the door shaft -D-.
-- Disconnect the connector -C-.