Convertible Top Drive Hydraulic Cylinder, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the convertible top. Refer to CONVERTIBLE TOP, REMOVING AND INSTALLING .
-- Release the clamp -4- and remove the retaining pin -1 and 3-.
-- Remove the hydraulic cylinder -2- from the main bearing.
If the hydraulic cylinder is being replaced:
- Hydraulic Line, Removing. Refer to HYDRAULIC LINE ON CYLINDER, REMOVING AND INSTALLING .
- Left hydraulic cylinder: free up the wiring harness and remove the Convertible Top Stowed Position Switch -F171- / Convertible Top Front Closed Position Switch -F202-. Refer to Convertible Top Open Position Switch -F171- /Convertible Top Front Closed Position Switch -F202-, REMOVING AND INSTALLING .