Convertible Top Compartment Cover Hydraulic Cylinder, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Bring the convertible top into its service position. Refer to Position : 1 .
-- Release the securing tab -1- -arrow- open the bracket downward and remove the cable holder -7- from the lower ball pin.
-- Release the catch -6- and remove the cable holder with the wiring harness from the hydraulic cylinder -5-.
-- Lightly lift the locking spring -3- and remove the hydraulic cylinder -2- from the ball pin -4-.
-- Remove the hydraulic cylinder.
If the hydraulic cylinder is being replaced:
- Hydraulic Line, Removing. Refer to HYDRAULIC LINE ON CYLINDER, REMOVING AND INSTALLING .
- Left hydraulic cylinder: free up the wiring harness and remove the Convertible Top Compartment -Open- Switch -F407-. Refer to Convertible Top Compartment -Open- Switch -F407-, REMOVING AND INSTALLING .