Convertible Top Open Position Switch -F171- /Convertible Top Front Closed Position Switch -F202-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the hydraulic cylinder for the convertible top drive. Refer to CONVERTIBLE TOP DRIVE HYDRAULIC CYLINDER, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring harness -1- and free up the contact connector with the unlocking element from the Wiring Harness Repair Set:VAS 1978 B on the connector housing.

-- Turn the hydraulic line -5- to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Release the catches -1 and 7- and remove the cover -2 and 6-.

-- Mark the installation position of the switch -4- for reinstallation.

-- Remove the switch -4- from the hydraulic cylinder -3-.