Convertible Top Control Module -J256-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the Relay and Fuse Panel 2 -SR2-. Refer to COMPONENT LOCATION OVERVIEW - RELAY PANELS, FUSE PANELS AND E-BOXES .
-- Release the retainer -1-.
-- Remove the bracket -2- for the control modules upward -arrow- and move to the side.
-- Release the catches -arrows- and remove the Convertible Top Control Module -J256- -item 2- slightly.
-- Disconnect the connectors -3, 4 and 5-.
-- Remove the Convertible Top Control Module -J256- from the mount -1-.