MOUNT WITH Convertible Top Locking Motor -V223-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the front trim panel. Refer to FRONT TRIM PANEL, REMOVING AND INSTALLING .
-- Using a small screwdriver, lift the locking spring -1- slightly and remove the ball socket -2- from the ball pin.
-- Free up the wiring harness -6-.
-- Remove the bolts -arrows-.
-- Remove the mount -5- with the Convertible Top Locking Motor -V223-.
-- Carefully push the retainer -4- on both sides to disconnect the connector -3-.