Rear Interior Lamp Mount, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while noting the following:
-- Clean the adhesive surface on the mount using the Cleaning Solution and let it dry.
-- Remove the protective film from the molded part -2- position on the mount and press on. At the same time pay attention that there is a smooth bonding of the convertible top headliner.
-- Install the mount on the "Bow 3".
-- Remove the protective film from the molded part, position the convertible top headliner -1- on the mount -3- and press on.
New convertible top headliner:
-- Make a cut-out for the interior lamp in the area of the mount in the convertible top headliner.