Testing Values and Process Specifications Table:
WARNING: This page is about a different variant/trim than selected.
| Fastening Element | Tightening specification [Nm] |
|---|---|
| Wheel bolt | 120 |
The adapter to loosen/tighten the anti-theft wheel bolts is located in the vehicle tool kit.
Procedure:
-- Remove the wheel bolt caps.
-- Tighten the wheel bolts diagonally to the specified tightening specification (for testing values and process specifications table. Refer to Testing Values and Process Specifications Table: ).
-- Press the wheel bolt caps on all the way using tool 8Z0.012.287.
-- If the adapter from the vehicle tool kit was used for the anti-theft wheel bolts, put the adapter in the vehicle tool kit.