Right Flange Shaft, Removing And Installing: Notes

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Circlip Pliers:VAS 5503A

Courtesy of AUDI OF AMERICA, LLC
Used Oil Collection and Extraction Unit:SMN372500

Fig 1: Identifying Used Oil Collection And Extraction Unit
Courtesy of AUDI OF AMERICA, LLC
Puller - Flanged Shaft:T10037

Fig 2: Identifying Flanged Shaft
Courtesy of AUDI OF AMERICA, LLC
Adapter:T10037/2

Courtesy of AUDI OF AMERICA, LLC
Sealing Grease. Refer to the appropriate Electronic Parts Information.

Removing

-- Remove the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Remove the right drive axle heat shield. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .

-- Place the Used Oil Collection and Extraction Unit:SMN372500 under the transmission.

-- Remove right flange shaft by fastening Puller - Flanged Shaft:T10037 to transmission housing -arrow-.

Fig 3: Identifying Right Flange Shaft By Fastening T10037

Courtesy of AUDI OF AMERICA, LLC

-- Use the Adapter:T10037/2 , if necessary.