Differential, Removing And Installing: Notes

Special tools and workshop equipment required 

• Gearbox Support:T40173A 
  Fig 1: Gearbox Support T140173

  Courtesy of AUDI OF AMERICA, LLC
• Engine and Gearbox Jack:VAS 6931 
  Fig 2: Engine and Gearbox Jack VAS6931 or VAG1383A

  Courtesy of AUDI OF AMERICA, LLC
• Puller - Flanged Shaft:T10037 
  Fig 3: Identifying Flanged Shaft

  Courtesy of AUDI OF AMERICA, LLC
• Shop Crane - Drip Tray:VAS 6208 
  Fig 4: Identifying Drip Tray

  Courtesy of AUDI OF AMERICA, LLC

• Before performing assembly work on the differential, drain the transmission fluid, secure the transmission on the assembly stand, and remove the clutch module with the right flange shaft. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .

Conditions

Courtesy of AUDI OF AMERICA, LLC

• Gearbox Support:T40173  with yellow chrome plated mount and joint housing -B- or applicable CE identification -A-.