All-Wheel Drive Clutch, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while noting the following:
-- Check the O-ring -1- on the all-wheel drive clutch input shaft -2- for damage and if necessary replace.
-- Apply a thin layer of Sealing Grease on the splines of the all-wheel drive clutch input shaft.
-- Place the all-wheel drive clutch -1- on the transmission and tighten the bolts -arrows- hand-tight.
-- Tighten the bolts -arrows- diagonally to the tightening specification.