Overview - Input Shaft 1
WARNING: This page is about a different variant/trim than selected.
- Small Needle Bearing
- Bearing "12"
- To the input shaft mounting 2 on the input shaft 1
- Large Needle Bearing
- Bearing "D"
- To the input shaft mounting 2 on the input shaft 1
- Sensor Wheel
- Input Shaft 1
- With splines for the 1st and 3rd gear
- Can be removed and installed individually without disassembling the entire gear set. Refer to INPUT SHAFT 1, REMOVING AND INSTALLING INDIVIDUALLY .
- Disassembling and Assembling. Refer to INPUT SHAFT 1, DISASSEMBLING AND ASSEMBLING .
- Thrust Washer
- For the 5th gear assembly
- Needle Bearing
- For the 5th gear assembly
- 5th Gear Assembly
- Synchronizer Ring
- For the 5th gear assembly
- Do not interchange with the synchronizer ring for 7th gear
- Synchronizer Hub
- Removing. Refer to Figure.
- Installing. Refer to Assembling .
- Thrust Pieces
- Quantity: 3
- Locking Collar
- Synchronizer Ring
- For the 7th gear
- Do not interchange with the synchronizer ring for 5th gear
- 7th Gear Wheel
- Needle Bearing
- For the 7th gear
- Inner Race/Needle Bearing
- For the 7th gear
- Removing. Refer to Figure.
- Installing. Refer to Assembling .
- Thrust Washer
- For the 7th gear