LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2023 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Gears, Shafts (Servicing - 7-Speed Dual Clutch Transmission 0CJ, 0CL, 0CK, 0DK, 0DN, 0DP, 0HL) (Coupe)) >> 35 Gears, Shafts >> Input Shaft >> Input Shaft 1, Removing And Installing Individually >> Installing

Input Shaft 1, Removing And Installing Individually: Installing

WARNING: This page is about a different variant/trim than selected.
GWWA35-10524Courtesy of AUDI OF AMERICA, LLC

-- Carefully guide the input shaft 1 into the gear set -arrow-. While doing so, make sure the needle bearings -A and B- are installed correctly.

-- Position the shift forks and secure with the bolt -arrow-.

GWWA35-10571Courtesy of AUDI OF AMERICA, LLC

AWD Vehicles

GWWA35-10522Courtesy of AUDI OF AMERICA, LLC

-- Warm the bearing inner race using the Inductive Heater:VAS 6414  to approximately 100 °C (212 °F) and push in all the way downward with the shoulder -arrow A-.

-- Install the circlip -arrow-.

GWWA35-10505Courtesy of AUDI OF AMERICA, LLC

-- Install the gear set. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .

scientia non olet · About LEMON Manuals