Input Shaft Seal, Replacing, Clutch Housing

Special tools and workshop equipment required 

• Puller - Crankshaft/Power Steering Seal:T20143 
  Fig 1: Crankshaft / Power Steering Seal Puller

  Courtesy of AUDI OF AMERICA, LLC
• Thrust Piece:T40300 

  Courtesy of AUDI OF AMERICA, LLC

Procedure

• Clutch, engaging bearing and slave cylinder removed. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .

-- With the Puller - Crankshaft/Power Steering Seal:T20143  carefully remove the seal -arrow- from the housing.

Courtesy of AUDI OF AMERICA, LLC

-- A waved washer -arrow- is located behind the seal, it does not need to be replaced.

Courtesy of AUDI OF AMERICA, LLC

• Pay attention to the installation position.

-- Drive the new seal in all the way using the Thrust Piece:T40300  .

Courtesy of AUDI OF AMERICA, LLC

-- Dual Clutch, Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .