Flywheel, Removing And Installing: Installing

Fig 1: Carefully Set Down Electro-Drive Drive Motor

Courtesy of AUDI OF AMERICA, LLC

Install in the reverse order of removal while noting the following:

-- Always clean the transmission housing in the area where the differential -arrow A- and the shaft seal -arrow B- are accessed.

• Replace damaged shaft seals located between the differential and the transmission housing -arrow B-.

-- Fill the space between the sealing/dust lip halfway with sealing grease. Refer to the appropriate Electronic Parts Information for the correct sealing grease.

-- Clean the input shaft -arrow-.

Fig 2: Identifying Input Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Lightly grease the input shaft splines with Grease for Clutch Plate Shaft Splines.

-- Slide the clutch module onto the input shaft -arrow- carefully without tilting it.

Fig 3: Identifying Flywheel Components, Remove/Install

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Puller - Clutch Module:T40176  from the flywheel -A-.

Fig 4: Attaching Puller - Clutch Module T40176 To Clutch Module -A-

Courtesy of AUDI OF AMERICA, LLC

-- Install the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .