Spring Element For Bumper Cover Bracket, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

Market-specific:

Courtesy of AUDI

-- Engage the support -1- with the spring element at the lower bumper carrier -2- and then pivot upward -arrow-.

• The tab -4- in the support must at the same time engage in the edge -3- of the bumper carrier.

Continuation:

-- Rivet the spring element or support with the spring element using the rivets.

-- Push the spring element all the way down and tighten the bolt.

-- Adjust the spring element. Refer to HEIGHT, ADJUSTING USING SPRING ELEMENT .