Rear Axle Toe, Adjusting
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Fine tooth ratchet, commercially available
- 21 mm internal multi-point socket, commercially available
Procedure
-- Remove the nut -1- from the threaded connection for the tie rod/subframe, and install the new nut all the way.
-- Adjust the toe by turning the eccentric bolt -2-.
NOTE:
To turn the eccentric bolt, turn the hex head at the >>top of the bolt<<.
- Axle alignment specified values. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
NOTE:
The maximum adjustment range is 90° to left or right of center position.
The geometric drive axle is automatically changed when individual toe settings are changed.
-- Tighten the nut and check the toe value again. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
Tightening Specifications
- Refer to OVERVIEW - TRANSVERSE LINK