Overview - Bumper Cover, RS 4 All, RS5 Before Product Improvement
WARNING: This page is about a different variant/trim than selected.
- Trim
- For the bumper cover
- Removing and Installing. Refer to BUMPER COVER TRIM, REMOVING AND INSTALLING, RS 4 ALL AND RS 5 BEFORE PRODUCT IMPROVEMENT .
- Bumper Cover Lower Section
- Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING, RS 4 ALL AND RS 5 BEFORE PRODUCT IMPROVEMENT .
- Rear Reflector
- With spring
- Removing and Installing. Refer to REFLECTOR, REMOVING AND INSTALLING .
- Small Reflector
- Removing and Installing. Refer to REFLECTOR, REMOVING AND INSTALLING .
- Bolt
- 2 Nm
- Bolt
- Quantity: 2
- 2 Nm
- Bolt
- Quantity: 3
- Tightening specification Refer to OVERVIEW - BUMPER COVER MOUNT .
- Mount
- For the bumper cover
- Side
- Overview. Refer to OVERVIEW - BUMPER COVER MOUNT .
- Bolt
- Quantity: 3
- Tightening specification. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
- Mount
- For securing the bumper cover
- Overview. Refer to OVERVIEW - BUMPER COVER MOUNT .
- Locking Mechanism
- For attaching the rear bumper cover to the upper mount
- Bolt
- Quantity: 2
- Tightening specification Refer to OVERVIEW - BUMPER COVER MOUNT .
- Mount
- for lane change assistance control module
- Overview. Refer to OVERVIEW - LANE CHANGE ASSISTANCE .
- Nut
- Quantity: 4
- 4 Nm
- Bumper Cover
- Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
- Cover
- For the towing eye
- Clip
- Quantity: 4
- Center Trim Molding
- Removing and Installing. Refer to BUMPER COVER TRIM MOLDING, REMOVING AND INSTALLING, A4 S LINE FROM PRODUCT IMPROVEMENT, RS 4 ALL, RS 5 BEFORE PRODUCT IMPROVEMENT .
- Side Trim Molding
- Removing and Installing. Refer to BUMPER COVER TRIM MOLDING, REMOVING AND INSTALLING, A4 S LINE FROM PRODUCT IMPROVEMENT, RS 4 ALL, RS 5 BEFORE PRODUCT IMPROVEMENT .
- Nut
- Quantity: 2
- 2 Nm