LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2023 >> A5 Quattro Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Bumpers (Coupe)) >> 63 Bumpers >> Front Bumper >> Air Routing, Removing And Installing >> Air Guide, Removing And Installing, A5, RS 4 And RS 5 >> Removing

Air Guide, Removing And Installing, A5, RS 4 And RS 5: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the wheel spoiler. Refer to FRONT WHEEL SPOILER, REMOVING AND INSTALLING .

-- Loosen the front wheel housing liner in the front and push it to the side. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

A5 and RS 5 Before Product Improvement

GWWA63-10856Courtesy of AUDI

-- Remove the expanding rivet -2-.

-- Remove the parallel parking assist front sensor. Refer to FRONT SENSOR, REMOVING AND INSTALLING .

-- Remove the bumper cover side piece -1- on the fender slightly -arrow-.

Continuation:

GWWA63-10857Courtesy of AUDI

-- A5: remove the bolts -2 and 3-.

-- Remove the expanding rivet -1-.

-- Remove the air duct -4-.

RS 4 and RS 5 Before Product Improvement:

GWWA63-11342Courtesy of AUDI

-- Remove the bolts -1 and 3-.

-- Pivot the air duct -2- slightly to the inside -arrow- and remove toward the rear.

RS 4 and RS 5 from product improvement:

GWWA63-11761Courtesy of AUDI

-- Remove the bolts -arrows-.

-- Remove the air duct -1- towards the rear.