PROTECTIVE HOUSING FOR Battery, 48 V -A6-, REMOVING AND INSTALLING, 0K4 AND VH2: Installing
WARNING: This page is about a different variant/trim than selected.
-- Insert the Battery, 48 V -A6- -4- into the protective housing -3-. Pay attention to the dimension -a- to the housing edge -5-.
- Dimension -a- = 2 mm.
-- Tighten the bolts -2- for the retaining bracket -1-.
-- Install the housing cover.
-- Push on the pressure vent tube until it audibly locks. Check the pressure vent tube for secure fit by pulling on it.
Install in reverse order of removal.
-- If necessary, adapt the new Battery, 48 V -A6-. Refer to Battery, 48 V -A6-, REMOVING AND INSTALLING, 0K4 AND VH2 .