PROTECTIVE HOUSING FOR Auxiliary Battery -A1-, REMOVING AND INSTALLING, 0K4 AND VH0: Installing
WARNING: This page is about a different variant/trim than selected.
-- Insert the Auxiliary Battery -A1- into the housing -1- and push all the way on the loosened retaining bracket -2-.
- The Auxiliary Battery -A1- must still be able to move.
-- Install the housing cover.
-- Tighten the bolt for the retaining bracket.
-- Push on the pressure vent tube until it audibly locks. Check the pressure vent tube for secure fit by pulling on it.
Install in reverse order of removal.
-- If necessary, adapt the Auxiliary Battery -A1-. Refer to Auxiliary Battery -A1-, REMOVING AND INSTALLING, VH0 AND VH0 .