Battery -A-, DISCONNECTING AND CONNECTING, 0K4 AND VH0: Connecting
WARNING: This page is about a different variant/trim than selected.
-- Secure the ground wire -4- on the body.
-- Connect the connector -3- to the Auxiliary Battery -A1-.
When the battery is reconnected, the following steps must be performed:
- Activate the power window regulator one-touch up/down function. Refer to the appropriate Service Information.
- Check DTC memories of all control modules and delete the displayed entry "Undervoltage" using the Vehicle Diagnostic Tester.
TIP:
After reconnecting the power supply, the ESP warning lamp can only go out after the vehicle has been driven a few meters.
Tightening Specifications